Terminal Configuration: Equipped with 230 V screw terminals and 0-10 V plug-in screw terminals, ensuring stable wiring for different voltage requirements.

Manual Operation: Each independent 230 V switch output supports manual control via a dedicated manual switch, enabling flexible operation when needed.

Installation Standard: Designed for DIN rail TH35 mounting (compliant with EN 60715), with bus connection realized through a bus connecting terminal for easy and standardized setup.

KNX software functions: Different dimming curves and dimming speeds, the same dimming

time, memory function, ON/OFF delay, staircase time function with/without manual OFF

function, scenes (up to eight stored brightness values can be retrieved), central function, logic

operation or priority control, blocking function, status feedback, behaviour on bus voltage

recovery.

Switch contact: for switching the electronic ballasts/transformers

Nominal voltage: AC 230 V, 50-60 Hz

Nominal current: 16 A, cosϕ = 0.6

Switching capacity: AC 230 V, 3600 W, cosϕ = 1

Capacitive load: AC 230 V, 16 A, 200 µF

Incandescent lamps: AC 230 V, max. 3600 W

Halogen lamps: AC 230 V, max. 2500 W

Fluorescent lamps:

AC 230 V, max. 3600 VA, uncompensated

AC 230 V, max. 2500 VA, with parallel compensation

LV- halogen lamps with wound transformer: max. 2000 VA

0-10 V interface: 0.12-100 mA

Voltage range: DC 0-10 V

Device width: 4 HP = ca. 72 mm

Contents: With bus connecting terminal and cable cover.

Inquiry Cart 0